DC2 spraying it matt black!!

**dsp26** · 21-06-2008 08:43 PM

Originally Posted by teaseR

keeep the paint cans in a warm - hot bucket of water...
this will thin out the paint so no blogging occurs

thanks for the advice though too late now

I would strongly advise this for the acryllic laquer then.. it's A LOT thicker than the enamel.

Ultimate goal would have been this but not game (Satin White)

**xenonkuraz** · 22-06-2008 12:27 AM

sex..

**NEED VTEC** · 22-06-2008 05:07 PM

spray can matt/satin paint jobs are always gonna have those streaks/linesthrough it.. to do it properly you need to put on a base coat of black then clear it, but use a matting agent in the clear, using a spray gun that is

but great can job though

**XP02ED** · 22-06-2008 07:24 PM

did you buff it or paint and dry

**defect** · 25-06-2008 09:53 AM

if your going to do the rear, make sure u remove the wing 2.
imho, the wing looks ugly

**PNS 001_EG3** · 25-06-2008 05:39 PM

hey mate never sprayed with cans but lines happen when you over lap when the spray gun is too close. try bringing the can further away. (yes it will not put as much paint down and youll have to do more coats but its more likly not to create lines. not to bad either. throw up some more pics

**XP02ED** · 28-07-2008 09:17 AM

any updates?

**NightKids** · 28-07-2008 09:33 AM

Yeah any updates? Or chickend out?

**Fo55il** · 28-07-2008 08:40 PM

bitched out hard

**XP02ED** · 29-07-2008 12:46 PM

atm, mines being experimented on.

the petrol door has been used incase i dont like the turn out, basically the petrol door is in satin black and was prepped very well which a clean finish came out and i do like it although have 1 issue on my mind.

if i paint my car satin black, this f*kers gna be hard to sell later