rear brake lights

**adu** · 16-10-2008 05:05 PM

brahh .. meet up

lmfao

im actually goin george river road maccas now

hahah

**danny_2132** · 16-10-2008 05:12 PM

lol cbf goin out rite now ive been driving all day so yer lol

wot globes do i need to get i think i might just pull da screws out with pliers or sumthingg.. or ne ov you have a better idea?

**An41** · 16-10-2008 05:13 PM

what do mean you the cover keeps spinning?
theres like a square plastic cover you can just pull that off and then the bulb socket should just turn 90 degrees and its free to pull out

**danny_2132** · 16-10-2008 05:16 PM

yer but i need the tail light which is the one next to it and u have to take the covering off and theres like 4 screws u gotta take out. and the screws dont screw out.

the square plastic cover is like for your signaling ones

and the screw keeps spinning not the cover

**An41** · 16-10-2008 05:17 PM

i replaced my brake light through that square panel
EDIT:no sorry that was on my EG, i remeber what I did, you push in on the little circle on the trim screw then I popped it out and pulled the trim back enough to reach in and replace the bulb

**danny_2132** · 16-10-2008 05:18 PM

serious? lol when i take dat little pannel off i can only see the yellow bulb

ill go check again later

but in the manual it says you have to removing the pannels at the bac to get the bulbs outt

**An41** · 16-10-2008 05:22 PM

woops, i editted my post with the way i did it

**danny_2132** · 16-10-2008 05:24 PM

lol ahk yer theres those popy things but theres also screws in it and the screws just wont come outt.

**An41** · 16-10-2008 05:28 PM

are you trying to take the whole taillight out?or are you having trouble with the bulb socket

**danny_2132** · 16-10-2008 05:33 PM

well there is a pannel covering the bulb socket and im having trouble geting the pannel off because the screws are stuffed and they dont screw out when i screw it, it just keeps spinning and nuthing happens