EM1 sway bar install

**EK1.6LCIV** · 10-11-2008 12:19 PM

all it has is a thread at ethier end but top bit has a rubber gasket and pivot head, hope that helps, what are u after?

**innozent** · 10-11-2008 12:21 PM

does it neccessarily to bolt to a rubber gasket, becasue mine dont

**EK1.6LCIV** · 10-11-2008 12:25 PM

I just got this off of an EM1, the endlinks have the rubber gasket over the pivot joint for a reason (so no dust/dirt can mess with the movement) they come as one piece

**innozent** · 10-11-2008 12:26 PM

does anyone know if a EK9 rearsway bar setup would include the rubber gast\ket too?

**EK1.6LCIV** · 10-11-2008 12:29 PM

It does, as should all, it would be a matter of time before the dirt and grit on the roads would compensate the movement and fail at that point

have a look at JDMConcepts pic on the forsale area of the EK9 sway bar kit, you can see it

**dahon** · 10-11-2008 05:51 PM

ask bowzer at modproject he sells them endlinks pretty cheap...
im pretty sure them endlinks all have that rubber cover to cover up the ball joint... where the rivets are though (the TOP of the endlink, ie where the sway meets the endlink) there should be a plastic shield to protect riveted part...
ek1s endlinks look like mine...