get a b18c7 - no need for engineering. and a dead stock setup should pull your car to low 14's if not high 13's. proven.
Too Pricey couldnt afford to get one when i was looking also that is the reason y i went the for b16a i even looked at the b18c vtir but that 8gees when i was looking
so am i better off going the buddy club spec 3+ if i am going to do head work
Too Pricey couldnt afford to get one when i was looking also that is the reason y i went the for b16a i even looked at the b18c vtir but that 8gees when i was looking
so am i better off going the buddy club spec 3+ if i am going to do head work
Wait till the currency picks back up and buy it from ebay US. Much cheaper then AUS traders/dealers here.
that $ could equal the difference in plopping a b18c7 in there (just engine and gearbox , re use everything else). buy engine $5k say , install , sell b16a2......you would be around the same price as you mentioned above.
IE cost you essentially $2-2.5k
Bookmarks