the lower bar is the standard tiebar. It does something. You should reconsider installing the beaks....
Anyway , to install you must have the lower control arms free IE loose (ends disconnected and shock disconnected and you simply take out the longer 14mm headed bolt , place the tiebar on then reapply the 14mm bolts.
ohok thanks... btw howcome you think i shuld reconsider? ye i just consider it as bling bling lol
ill assume you are owner of integra R, he is saying reconsider, because they come with this standard, just looks a bit different. the bar that is in the picture does exact same thing, so inface you are just weighting down the car lol.
but i think it looks cool, i had one on my eg.
if you can be bothered installing it, then go for it. it also scrapes everywere. none the less its a very cool part.
Yeah basically you don't need it on the R, when I fitted mine I removed the lower bolt on the frames of the ABS line on each side of the subframe, took the bracket to the work bench and used a grinder to cut away the part which fouled the tie bar and reattached the brackets slightly re-routing the ABS line underneath the tie bar mounts.
Pic added: perhaps I should re-route it over the tie bar instead
i dont remeber moving any of those wires out the way, all i did was take out those two bolts and line it up and put them back in. i did some other wierd shit, but you dont need to. for some reason i took out sways and pretty much everything else lol.
btw if your a bit confused, were the green arrow is pointing that thing does same as beaks
Bookmarks