h22a conversion

**teg94** · 12-01-2009 07:27 PM

i have read numerous DIYs for h22a conversions....

can someone please confirm that if i drop a h22a into my EG, using hasports, that the driver side original mounts need to be cut to fit the engine in...

i want to confirm this before i go ahead hacking that mount..

thanks.

**fatboyz39** · 12-01-2009 07:41 PM

Pretty sure you have.

**teg94** · 12-01-2009 07:58 PM

yes i have decided it has to go....

can someone please tell me whether i need a conversion harness to connect the ecu 95 EG (breeze) to h22a??

if so, where can i get one?

**SuiJin** · 12-01-2009 08:00 PM

http://www.civicland.com/forum/honda...swap-info.html

read this one its the best h22a conversion post ive seen.

**barefootbonzai** · 12-01-2009 08:12 PM

Originally Posted by teg94

yes i have decided it has to go....

can someone please tell me whether i need a conversion harness to connect the ecu 95 EG (breeze) to h22a??

if so, where can i get one?

You're gonna an awsome time doing the conversion if your car is a breeze. You need to change a lot of wiring, join up some fuel lines and change your fuel tank in addition to the link above.

**teg94** · 12-01-2009 08:22 PM

fuel system is done already...

**barefootbonzai** · 12-01-2009 09:27 PM

Originally Posted by teg94

fuel system is done already...

well done...

**jdmTYPE R** · 12-01-2009 11:15 PM

and subframe is different with breeze, u will have problem bolting up the rear mount

**Benson** · 13-01-2009 08:37 AM

Originally Posted by jdmTYPE R

and subframe is different with breeze, u will have problem bolting up the rear mount

??? Never heard of this? got any links ?

**mr180sx** · 13-01-2009 09:16 AM

Originally Posted by jdmTYPE R

and subframe is different with breeze, u will have problem bolting up the rear mount

never heard of that one as well. pretty sure all eg chasis is the same. just have to remove driverside mount.

if you have a breeze good luck.have fun taking dash out. hehehe

**teg94** · 13-01-2009 06:19 PM

rear mount went on fine - had no issues with that one...

**jdmTYPE R** · 15-01-2009 09:07 AM

Originally Posted by Benson

??? Never heard of this? got any links ?

there is no link i worked on it and rear mount doesnt line up to the bracket hole ives done couple it they never lineup, GL onword is fine only breeze is different ,the mount sit about 1cm away then normal eg does...had to change the subframe from a gl onwards ...even GPC told me its different in the first place and i didnt believe him until i worked on it

Originally Posted by mr180sx

never heard of that one as well. pretty sure all eg chasis is the same. just have to remove driverside mount.

if you have a breeze good luck.have fun taking dash out. hehehe

thats what i thought was wierd to....the mount hole with the braket hole was way off...this was with all of the breeze i worked on..

Originally Posted by teg94

rear mount went on fine - had no issues with that one...

mount will bolt onto the subframe fine but getting the bracket to line up to the hole might be a problem..