nar mate 1st time doing it and wasnt that hard at all
not sure bout the ratios mate just try do your best
i practiced on a small block of wood couple times before
i actually started on my car
and i surgest that to everyone who wants to try it
Im not an expert but during year 11 & 12 I did a fair bit of composite work (Carbon/Kevlar). I can't remember our exact ratios but we certainly knew when we had them wrong
Where abouts on the car does that piece actually go?
yer man that fit snug
just dont make the thick resin around the edges
i found a shop in seven hills for all the nsw members
but most fibreglassing shops should stock them
good thing to ring around thats what i did
thanks for the rates guys keep it coming
1. was there any noticable warpage/shrinkage once the resin cured?
2. working on the same principle, if i inserted say a sheet of say baking paper in between the mould and the fibre cloth, do u think i'd be able to remove the cured fibre off the mould, or would the resin stick to the baking paper anyway?
Reply With Quote
Originally Posted by nisboi40
Bookmarks