HOW TO: Install speakers in your Jazz (graphic intensive)

**TypeG** · 17-09-2004 12:42 PM

install by JB cost $150 as a basic fee for bolt on man.....
i can send u my speakers diagram =)

**wynode** · 17-09-2004 12:50 PM

Looking good Chris........good to see someone taking the time to take photos and do a write up!

**Kit** · 17-09-2004 01:07 PM

Originally Posted by dc

u know, a simpler solution than cutting an xtra 6 small mdf blocks and putting em behind the rect. holes would be just to use nuts+bolts+washers(+foam)...

Yep, there are probably a multitude of methods for securing it, and I considered the nuts and bolt and washer method.

but I thought that the MDF blocks would be simpler and more secure, plus less likely to scratch the door itself (which might cause rust at a later date)

**Civic Si** · 14-12-2004 08:30 PM

Wat is the most suitable size speakers to fit in a Jazz?

**spoon fit** · 14-12-2004 08:33 PM

Originally Posted by Civic Si

Wat is the most suitable size speakers to fit in a Jazz?

6 inch.

**Civic Si** · 14-12-2004 10:06 PM

cool thanks!

**TypeG** · 14-12-2004 11:17 PM

no
i find a way you can screw the speakers straight in with smaller speakers

**Paul Brooksbank** · 09-03-2009 09:06 PM

For the correct door trim removal instructions, try the following link. http://www.hondafitjazz.com/manual.htm

This also tells you the entire maintenance schedule and instructions.

Trust the Poms eh boys ?

**chan** · 10-08-2009 10:35 PM

Hello,

I have removed the door handle cover and the 4 screws.

How to remove the door release handle and the door trim? Are there any tools required?

**redmugenjazz** · 10-08-2009 11:50 PM

push to door handle towards the front of the car and pull outwards, there should be a clip holding the latch with a extender bar to open the door, flick the latch out with a flat tipped screw driver and flick the rod upwards - remove the door handle. Remove the door panel from the bottom, there should be a opening about the middle of the bottom of the door trim, insert a flat bar or long flat tipped screw driver and pry it out slowy. if u got small enough fingers - just use that at least u get a feel of what u are doing. hope this helps

**TGS79** · 19-08-2009 02:33 PM

Hi Guys

if your intersted I think Stinger Australia does a radio replacement dash kit so you can put in a double or single DIN head unit - if you want to take your up grade further.

**samsung001** · 08-09-2009 05:01 PM

Originally Posted by TGS79

Hi Guys

if your intersted I think Stinger Australia does a radio replacement dash kit so you can put in a double or single DIN head unit - if you want to take your up grade further.

hi...just wondering how much would that cost? does it effect the warranty? any thought ?