Making a silencer

[kraiye]

i've always wanted to try this...
- grab an off-cut of stainless steel sheet metal from a metal recyclers - they often just give away smaller pieces.
- cut out a circle small enough to fit inside your muffler - leave a tab on either side of the circle.
- cut a hole in the middle of this circle to make a "doughnut" with tabs.
- bend the tabs back at 90 degrees.
- drill a small hole through the middle of each tab.
- stick it inside the end of your muffler and drill holes in your muffler to line up with the ones in the tabs.
- attach the silencer with small, stainless nuts & bolts.

For extra silencing you could put stainless steel wool on the inside of the silencer you made. that way u could use both and they'd be easy to remove.