Crx gen ii b16a query

[skiiboy90]

Hey guys,

another quick question, the guy i bought my car off (88 CRX) did the b16a swap, and unfortunately the aftermarket headers he attached are bodgy, as they are hitting the subframe and beaten with a hammer into place.

what headers do i need to clear the subframe?

any ideas / any for sale?

cheers guys,

George.

[CRXer]

it depends what mounts were used for the motor & what headers are on it.

TODA headers clear with hasport mounts in place but only just.

another alternative is to replace the subframe with a traction bar setup,like avid(jdmyard) or full-race,u will have heaps of room for most headers then.

[CRSEX]

i had the same problem.. i got fujitsubo 4-2-1 headers and it fixed the prob! they were first gen ones with two O2 sensor bungs, only down side was it cost me $1.400 brand new! but you get what u pay for!