Sup..
I took my car to the garage to have the box oil changed..
Once it was up on the ramp, we where looking up at this abomination of a drain bolt.
The "once" open 1/2 drive bolt was rounded off... and shards of metal everywhere. Some **** tried before and failed...:-/
It also has sealent all on it, so it's stuck in pretty good.
So the mech tried removing the fill bolt, and again had no luck (with a huge as **** breaker bar)
His words "I don't want to break something, so i'll stop about now"
I could top up the oil through the shifter hole, but that's pointless. I want to put fresh oil into it.
Any ideas / tricks on how to remove the drain OR fill plug?
I was thinking of removing the drain plug, and finding a pump that not only pumps, but also sucks, and removing the old fluid that way.
Bookmarks