Buddy Club racing spec condenser installed

[learner]

learner, where did you ground the 3 cables? can you show me the location of the 3 grounding points?

euro77... here you are (just got my CAI installed last week )

i place the condenser to the battary cover like Peekay34 did.


this is one of the best place to connect the ground wire. (i found it in the owner's manual) is on the driver's side next to the air-con... you will see a thick silver cable connect from engine to the chassis.


P.S. the longest Buddy Club cable will not be long enough to get u there if u place the condenser where i put it. so i got 8ft 4 Gauge Phoenix Gold Power cable for tat. here is da link of the cable... is blue as well
http://www.sfxaudio.com/products/dis...p?ProdId=61001

here is how i run through the cable.



the second place is under the air-intake box. you have to take tat off to see tat place. there you will see a thick silver cable (like above) connect to the chassis. if u not sure how to take tat the box off.. pm me



and about the third ground ... i am still looking for a good place...
i just screw it to here at the moment.


i saw FEEL's(japan) tight the ground cable to the engine near the intake part on their euro.
i dunno i should do tat or not since i am not a prorssional, i am afraid to un-tight any bolt on the engine.....

here is their page
http://www.hondatwincam.co.jp/info/temp2003-05-000.html

good luck & have fun...
post it if u had any different idea.