My EK CXi

[big tone]

Now the door trims..

This is the before photo (no afters yet as it was so dark by the time I was done and I've been working the whole day today):


Finally found the right tool to get the mutha f**ker horseshoe pin out. $5.00 piece of metal from Autopro.


After endless sawing and pulling and ripping out came the arm rest/handle.


Bonded with MaxBond:


Reattached with epoxy:


More pics tomorrow.. Maybe!

hey man just wondering how you reatached the armreat back on as i thought of doing the same thing and they are plastic rivited on.. whats your secret.. have any detailed pics?

[neo_phase]

hey man just wondering how you reatached the armreat back on as i thought of doing the same thing and they are plastic rivited on.. whats your secret.. have any detailed pics?

Hey mate just use epoxy to re-attached the arm rest. You'll need to apply some pressure from the other side of the arm rest to make it stay. epoxy is good as it's construction grade. It is however quite a permanent solution so it would be quite difficult to remove later on.