Jdm b18c

[kairi_k]

hey guys how do you tell if a B18C is JDM? the engine codes on the block??? where do i check and what should it read? B18C1....???

cheers

[POPSIKAL]

jdm b18c block will just read b18c, that is out of the sir-g which is the jdm version of the vti-r here in australia, b18cR is from the jdm type r, hope that helps you mate

[saikou27]

http://en.wikipedia.org/wiki/Honda_B_engine

jdm engines all read B18C. this applies to both the gsr and type r motor. the type r motor does not read B18CR like mentioned above.

[POPSIKAL]

ok wasnt sure if it did thats why i didnt say it read that, but thanks saikou

[g_kn]

" b18c "

[mooks145]

jdm B18C reads as B18C, not B18cR

[ajbm]

JDM = B18c (engine number) SiR/SiR II integras
USDM B18c (engine number) GSR
AUDM = B18c1/b18c2 (engine number) Vti-R
jdm spec slightly produce more power than their international counterparts

[markoJEK1]

B18C1 is from a gsr (usdm vti-r)

B18c
xxxxxxxxxx
JDM SiRg + ITR
ITR has red engine cover = 200ps (147kw)

B18c2
xxxxxxxxxx
AU VTiR = 125kw

B18c5
xxxxxxxxxx
= USDM ITR = 195ps

B18c7
xxxxxxxxxx
= AUDM ITR = 190ps - (141kw)

[kairi_k]

mine says b18c1.....? not sure what the one is? the start of the engine no. do jdm engine numbers tart with a one?

[GSi_PSi]

if its b18c1 its usdm vtir motor.
Check your engine block. I think you are confusing your vin number.

[SuiJin]

B18C1

* VTEC (Dual Stage Intake Manifold)
* Found in :
o 1994-2001 Acura Integra GS-R (DC2)
+ Power : 170 hp (127 kW) @ 7100 rpm & 128 ft·lbf (173 N·m) @ 6200 rpm
+ Redline : 9000 rpm (limiter @ 8500 rpm)
+ VTEC Switchover : 4400 rpm
+ Intake Manifold Switchover : 5750 rpm
+ Displacement : 1797 cc
+ Compression : 10:1
+ Bore : 81
+ Stroke : 87.2 mm
+ Rod Length : 137.9 mm
+ Rod/Stroke : 1.58
+ Transmission: s80
+ VTEC Engagement: 5800 Rpm

http://en.wikipedia.org/wiki/Honda_B_engine

[defect]

Yep it should just say B18C with a bunch of numbers under it.