EP3 Type R

**SuperSteve** · 23-10-2009 04:21 PM

I'm running mugen mounts with insert in the oem rear engine mount. Have slight cabin vibration.

**Mugen_B16B** · 23-10-2009 05:28 PM

how bad is the vibration on a scale of ten? innovatives r pretty bad

**Rai-C** · 23-10-2009 05:38 PM

who drove past me today at the hume hwy / hoxton park rd rights today

haha

i love spotting EP3s

**NightRyder** · 23-10-2009 06:24 PM

Back by popular demand.

Sydney Coffee Meet set: http://www.ozhonda.com/forum/showthr...44#post2525144

Roll call!!

**denrie** · 23-10-2009 06:48 PM

Can I come even if I don't have my car? LOL anyone want to pick me up? :P

**white_ep3_civic** · 24-10-2009 09:49 AM

Just wondering how to change the gear box oil in our cars? Is there a plug like the oil sump has and how does it be refilled? I no this sounds like a stupid question but I have neva done it b4

**white_ep3_civic** · 24-10-2009 12:44 PM

Not sure if this has been posted yet but found those windscreen wiper arms. They from supercheap and the brand is tridon

**pair08** · 24-10-2009 02:54 PM

yeah i managed to pick up innovative mounts from ebay for around 340 shipped.

took a while but..

**Mugen_B16B** · 24-10-2009 05:14 PM

nice, u bought it at the right time to, 92c is fkn sweet

make sure when u install em ur mounts r lined up lol, i learnt the hard way

**chargeR** · 24-10-2009 06:02 PM

Originally Posted by white_ep3_civic

Just wondering how to change the gear box oil in our cars? Is there a plug like the oil sump has and how does it be refilled? I no this sounds like a stupid question but I have neva done it b4

It is fairly easy if you have done minor DIYs like changing your oil before. There is a drain plug at the bottom of the gearbox on the passenger side that takes a 3/8" drive to undo and then there is a fill bolt (17mm socket) a little further up in the same area of the gearbox. Fill it until the excess spills out the fill hole with the car level, it should take about 1.8L. Both plugs have aluminium crush washers on them so if you wish to replace them (which is a good idea) you will need a 14mm and 20mm crush washer.

I use a funnel taped to a medium length bit of hose to fill it but you could use a small hand pump if you are baller.

**Ozluder** · 24-10-2009 08:15 PM

All

What suspension system is everyone running? I'm after a setup that is sporty yet comfortable as I use this car as my daily driver. I was thinking of getting the TEIN basic damper.

Thanks