Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
Aim: Install an SMD/LED strip in the driver and passenger foot area. It will act like the dome light. Dim down when u turn on the car (doors close), turn on when doors open or when the car is unlocked or when u take out the key when u turn off the car.
Required: SMD/LED strip. Tape. Cost $10 for 2 strips. Well worth it for the finished product.
Steps:
1. Locate the fuse box under the driver side steering wheel
2.Feed the wires of the SMD/LED Up through the side and feed the wires to the fuse box
3. Locate the plug for the dome light. It is the plug next the the big yellow one and has 2 wires going into it.
4. Grab the 2 wires that you fed to the fuse box and connect it to the back of the plug. You should have enought room to shove more wires in. And test the + and - ends of the cable or the led wont turn on.
5. Repeat for the passenger side.
6. Peal off the adhesive on the Strip and apply it on your car.
7. Finished and now you can test it.
Other comments
Videos below so you can see it in action.
JAZZ:
COROLLA:
Bookmarks