the little CRX that could.

[~Sp33~]

Hmm, that's an OBD1 intake manifold on that new engine, Is the motor out of an EG SI (Probably why the mounts are different)? You'll need an OBD1 distributor if that's the case, your original dizzy wont have the exhaust cam sensor needed.

Goodluck on the swap mate! Sounds very similar to what i've got planned (building for turbo )

[EDracer]

Hmm, that's an OBD1 intake manifold on that new engine, Is the motor out of an EG SI (Probably why the mounts are different)? You'll need an OBD1 distributor if that's the case, your original dizzy wont have the exhaust cam sensor needed.

Goodluck on the swap mate! Sounds very similar to what i've got planned (building for turbo )

your right the motor is OBD1 not 0BD0 but i am only using the Block and intake manafold, all other sensers i can move from the first motor, like the exhaust cam sensor. its coming along well, almost there now, just need to attach the mounts to the motor (have already changed the block mounts), put it into the engine bay and plug back in. should be up and running sat night

[~Sp33~]

your right the motor is OBD1 not 0BD0 but i am only using the Block and intake manafold, all other sensers i can move from the first motor, like the exhaust cam sensor. its coming along well, almost there now, just need to attach the mounts to the motor (have already changed the block mounts), put it into the engine bay and plug back in. should be up and running sat night

Awesome, good luck

[EDracer]

nice man when its all done gotta come cruise out with some of us one time..

Most definatly will. almost done so anything this sat night or sunday i could do.

Awesome, good luck

thanks man, hows your 4WD going? and any luck with the Crezida?

[DEMON83]

should be up and running sat night

I hope so... lol its hard work supervising in the hot sun!