b20 vtec question

[IEVAQ8]

hey guys, i'm really sorry if this has been covered, but i couldnt find it.....so dont flame me, just show me the light...

i was wondering what the outcome would be if you installed a b18c itr crank into a b20 and then built it with vtec head.....

would it have any effect on displacement???

thanks in advance...........

tom

[GSi_PSi]

Umm you would have 1.9 Litre so yes it would affect your displacement. the B20 crank is 89mm vs the 87mm ITR crank.
Why dont you just micropolish and balance the b20 crankshaft, sure it wont be lighter but the extra displacement will make up for it

[IEVAQ8]

thanks man, i wasnt sure if it would loose displacement or not.............

its not about the weight or power..............it was a general question

thanks again

[string]

87.2mm crank vs 89mm crank = 2% loss of capacity. With an 84mm bore this means a touch under 40cc is gone. 81mm vs 84mm bore = 7.5% gain in capacity.

[IEVAQ8]

so which is which???

lol

[string]

A smaller crank (87.2) will displace less volume than a larger one (89).

[IEVAQ8]

yes yes, but which size crank is b20, and which is itr b18c???

[string]

Read post #2.

[MikeyG]

the B20 crank is 89mm vs the 87mm ITR

[IEVAQ8]

oopppssss.............i did read it, i forgot.........lol

thanks again for ur help guys

[jdmTYPE R]

why dont u use a b20 crank in a b18c block..b18c block is safer then a b20

[90LAN]

or get a 2lt stroker kit in a b18c