Lets Talk d-series

[will13]

Im not doubting the mighty old d16a8. Great old engine , i had one. But it put exactly 58ishkw atw in 2004. Well maintained.

Interesting. Perhaps mine is just better? lol

I'm going to a dyno day on saturday so if i have time to get a turns I'll be posting dyno sheets

[bennjamin]

Interesting. Perhaps mine is just better? lol

I'm going to a dyno day on saturday so if i have time to get a turns I'll be posting dyno sheets

perhaps. Or the dyno you tested your car had adjusted its ramp rates etc....giving it an inflated read out figure. No two dynos are exactly the same readout ! My old Si pulled hard for what it was and beat many a SSS back in the day too. But it had a low kw @ the wheel and ultimately would not get any better

[will13]

That WAS at the 1/4 mile right Will? LOL

it was 'A' quarter mile...not so much 'THE' quarter mile lol

[beeza]

Ahahahahahhahahahaaaa

[JasonGilholme]

perhaps. Or the dyno you tested your car had adjusted its ramp rates etc....giving it an inflated read out figure. No two dynos are exactly the same readout ! My old Si pulled hard for what it was and beat many a SSS back in the day too. But it had a low kw @ the wheel and ultimately would not get any better

dyno's can read low too. lets not forget that. They're only a tuning tool at best.

The real world results is what counts. 1/4 times and comparisons to other cars in the real world is the best way.

Rock what ya got

[TheSaint]

I think at 300K you'd be needing to replace OEM parts anyway. Turbo or not!

actually it runs really well, i have replaced anything i can think of that is due to fail - all hoses, some cables, some belts, etc

always run on OEM oils and parts

tough little bastard =)

[beeza]

hehehe nice,any vids man?

ive just got mine running
[URL="http://www.youtube.com/watch?v=n8KMfV7L92E"]

Sweet,I need audio!

Anymore vids of her going

[Gio]

I've priced one for a y1 at about $600 US which imo is REALLY cheap. See below


The kit contains:
-FJ R Spec Custom Length D16 I Beam Connecting Rods
-ARP 2000 3/8" Rod Bolts
-ARP Lube
-YCP Vitara pistons (75mm / 75.5mm / 76mm)
-Wrist pins and C clips
-Piston rings (Hastings or NPR)
-OEM Timing Belt
-Japanese Water Pump
-ACL Rod Bearings
-ACL Main Bearings
-ACL or King Thrust washers
-Full engine Gasket & Seals set--> Its all the gaskets and seals you will need for your engine from the oil pan and up to the head.Metal 3 layer Head gasket (approx .030 thickness)


Looks like you'd have to source the snail from elsewhere though

So will also need snail, pipes, radiator....what else?

[will13]

havnt looked that much into it. im not that cluey with turbo setups either

[hitoriko]

For my D i've spent 100 for genie headers... a VAFC2 is the next point of call after the extractors are fitted as the tune will be of help and if i go b-series later i can still use the VAFC2 as my piggy back but most of my cash is being thrown at suspension

[beeza]

Smart thinking!

Can't go wrong with those genie headers for $100,great score!

[TheSaint]

what do you use in place of a VAFC when your car isnt VTEC?

SAFC? or is there something else?