Lets Talk d-series

[A-man]

not yet man.

alot of it u can tune out urself. uve already got timing. and if u play with ur fuel pressure you can squeeze a little out of it whilst not spending alot. chipped ecus r cheap to for somethin like crome or neptune if u do it u may aswell do it properly. i dont see y a vafc wont work still u just dont have the vtec map.

i run my d16 with the little work it has off oem ecu no chip

[dougie_504]

a d16a8/zc makes exactly 96kw @ the flywheel dead stock brand new.
Around 55-60kw ATW. The d16y1 and d16y8 both make 96kw too. Similar kw at the wheels too.
Less since its so old now.

You're correct, my mistake. The Euro D16 DOHC makes 93.2kw.

As for 55-60kw ATW I'd have to think that either your dyno run is wrong or there's something stuffed with your engine that you just haven't noticed. I wouldn't expect a FF Honda to lose anymore than 30% of power from fly to wheels, even at 20 years of age.
I'm sure if we dig around we can find something a little more concrete...

[grifty]

anyone put their D16 n/a on a dyno yet? id be intrested in seeing power figures.

[saikou27]

most figures ive seen on dseries.org is around 70-75kw atw with i/h/e. and the american dynoes tend to read a bit higher than ours

[Gio]

beeza did ages ago

[grifty]

beeza did ages ago

do u have any clue where i can find it? or should i just wait for beeza to come online?

[dougie_504]

He posted it already on page 62

[will13]

well i was supposed to go to a dyno day today but i slept in lol

[dougie_504]

In March CRXAustralia is doing a dyno day, so we'll probably have some D16A8 results, with plenty of B's also

[EK1.6LCIV]

that would be a nice event, I might come for a look

[90LAN]

ryan you have a dyno sheet for your car why dont you post it up

for people to see what few mods on a dseries gets

[beeza]

I wanna dyno mine again after I put the cam in!

WOOT WOOT,that would be sweet