how would i go abouts to get the FD1 on HID. need help

[curtis265]

a single 1W led is superior to one with 5 smaller LED's, definitely.

sorta like a quality over quantity approach.

[Muzzy]

gotcha!

[evil_1998]

My 5 bulb S.M.D

[Muzzy]

see that looks alot brighter IMO.

where did you get them from evil_1998 ?

[kawai]

where did we all ended up mounting the ballast, and did we stuck em on with double sided tape or bolts or ties?

im thinking about the top side like the pictures with the kinix kit photos. any better idea?

[curtis265]

Do you see that thing connecting the fender to the chassis? like... near the bottom of the photo?

I cable tied it on there.

[kawai]

the right angle bar? it dont have have any airbag sensors there right? my initial though was to place it there too when i had a look under the car. does the ballast get hot? cus i have a little black box which hangs of it dont know if i should just place it on top of the ballast.

[curtis265]

Well, it doesn't really do muh except hold the fender up - there weren't any wires on it or anything :S

I hope s omeone else did this... lol

[Muzzy]

Yeah I think I cable tied mine on that bracket too from memory. My cable ties actually go through the holes and around the ballast to hold it on tight. I hope the ballasts don't get hot coz that means the cable will melt after a while. Have to open it and double check over the weekend to make sure it's still ok. Been about a month or more no issues.

Recently put on my H11 foggies and they were a little tougher as there's less room. But I bolted one of those (with the bracket) that caused some room/positioning issues.

[kawai]

any one bothered to adjust their light after installation? cus its seems like a bi**h to do.

[Muzzy]

any one bothered to adjust their light after installation? cus its seems like a bi**h to do.

How do you adjust them? I can tell that one of mine is slightly off too..

[kawai]

There is a hole or a screw on the top of the headlight under the plastic that cover which, covers the headlights and radiator. The plastic is held down by the nobs which are like for the plastic cover in your wheel arch (the thing which you pulled off to install the hid) but they don't have a notch like the ones there so it makes it a bit harder to do. and im not sure if there are any hidden screws.

btw on the top of the plastic cover (over light and radiator) there is a sign there on both left and right hand side with U and D im guessing is directly under there.