Your Mods To 2006-2011 FD Civics

[black8thgen]

yo, guys this is out of topic randomly, but can anyone tell me what these hoses are for as i need to know asap. regards to intake arm for FD2

im assuming that 1 of them is a breather.
Also is it possible for these two hoses to be connected to 1 with a T-piece connector?

both breathers - pretty sure both of them need to be connected separately like it is there - try not to mess around with any intake stuff or engine light will haunt u as lots of ppl hav experienced.

[black8thgen]

just another question will 97 prelude wheels fit in the civic fd1?

i think is
5X144 16X6.5 +55 i think this is the Tyre size 205/50 R16 87V tires



i have matched them up with the back wheel look about the same but the tire is about 1" ~ 1.5" wider but too lazy to take my wheels off to check cus only have 3atm in the garri lolz.

they fit, but JUST. lol - i used tims as spare tyres for a week... but its perfectly fineeee haha. buy tims ones =P - theyre at my house atm tho lol

[ekdez]

ekdez, your dp stole all my attention from the FDs =P

shes a stunna hey

[black8thgen]

=O whered u get pics of my gf from?!?!

[ekdez]

the day she came over to my house and lay in my bed
ok back on topic LOL

[Stig]

LOL oh snap

i saw that coming... or she did?

[black8thgen]

Ouch =[. Haha. Dw man sharing is caring =]. Anyways... Getting new intake tmrw yay lol

[ekdez]

lol what intake u get?

[Atjo]

you wont get "deep dish" on a civic fd.
its just a fact of life. Honda's weren't made for "deep dish", if you wanted that grab a nissan or a lexus etc..
having said that they can get very close.. but just remember some body work will be needed.
wait till i get my new rims and ill show you.

i know there is a guy on this forum, threesix, and his rims have a credit card length of dish on the rear and a bit more then half on the front =]

curious to know how much stig or ivan have tho..

You can, it's just depends on the design of the rims like Ivan's Estatus D2 and how much camber you want to have. My camber was -6.5 when i set my camber kit to the max in order to avoid scrubbing on my RB1 and my rear wheel is 20x9.5 +15 with 10cm dish. Or flare the guard if you don't want to have camber wear. So anything could be done.

[black8thgen]

got simoto CB2 - the new carbon charger hehe and connecting cold air feed, hopefully get some response out of it

[xqwzit]

^did you consider injen sri ?

[9ineto5ive]

got simoto CB2 - the new carbon charger hehe and connecting cold air feed, hopefully get some response out of it

thats what i got, the Simota Carbon Charger 2 and now its installed with a duct to the front for cold air. the intake gives a better throttle response, mayb a little power gain and is noisy when full throttle. but other then that not a bad intake