EP3 Engine to EU3

[toyaracing]

hi guys,
can EP3 engine installed into EU3?..coz it seem batery & fuse box @ opposite place..let say i bought EP3 front cut..can i put everything into my EU3 engine bay?..tq

[SHU-ES1]

it would fit, just need a few bits and pieces to make it work. there is already another thread open about this, search bro!

[Perry]

Try looking on honda-tech there is a few people have done it.

[toyaracing]

it would fit, just need a few bits and pieces to make it work. there is already another thread open about this, search bro!

owhh sorry.,im stil new & not familiar wif this forum..i will search bro..anyway thanks

[OMG.JAI xD]

Its pretty close to bolt on bolt off.

[Riced_Civic]

yes you can do it, but is it worth it cos in the end itll cost close to same as buying an EP3.

theres a lot of custom thing u need to do and you need to get rid or trim a few of the cars bits.

rad support has to be trimmed to fit the motor
fire wall has to be cut to fit exhaust
bits of the motor webbing has to be trimmed to fit in the bay

[toyaracing]

thanks for da info..tq guys...

[toyaracing]

hi guys,need more info...can EP3 rear disc fit to EU3 since handbrake at diferent place...EU3 on the left foot brake pedal..while EP3 besides front seats...

[Riced_Civic]

do u mean a full brake conversion or just the rotors?

if the just rotors then no.

full conversion Yes.

[SHU-ES1]

eu3 handbrake is in a similar position to the ep3. the eu3 doesn't have a handbrake near the foot pedal like in some cars.

[toyaracing]

eu3 handbrake is in a similar position to the ep3. the eu3 doesn't have a handbrake near the foot pedal like in some cars.

but my EU3 handbrake is under dashboard..have to press by leg..and release by pull a handle underdashboard oso..dat handle is under sidemirror switch..

[SHU-ES1]

hmmm.. maybe you guys in malaysia have a diff. setup to ours? mines next to the drivers seat?