dc2r front sway bar install [HELP URGENT]

[LLS]

hey, Im trying to install a front dc2r sway bar into my eg hatch. But one side of the endlinks dont sit straight/flush. As far as i know there are no other parts needed to install the sway besides the sway bar itself and dc2r endlink.

Also does it matter if the end of the sway bar is on top or under the lca? Example image below from jdmuniverse. This is an Ek and the sway is mounted under the lca

[yellows2k]

Can I ask why u decided on a frontsway bar? Wat r the benefits? I just installed the dc2r and asr into the rear of my eg5 but didn't look at the front, wat gains r to be had?

[bennjamin]

Trial fit first - loosely connect the D bushes and mounts ( subframe ) and the swaybar endlinks should
be ONTOP of the lower control arms. Remember to use ITR endlinks not standard ( different design)

Is the front of the car off the ground ? Or just one corner ? You can lift or drop the opposite side to pivot the opposite end of the swaybar down or up

If the swaybar is truly out of whack , there is a good chance
it's bent from an accident. You have been ripped off get a refund

[LLS]

cheers ben, i re-did my bushes loosely and then put on the endlinks and it sat flush.