EP3 Type R

**Nepolian** · 14-08-2010 08:08 AM

Hey guys, I have split rear exhaust hangers so I'm getting harder urethane type ones. I have sourced some (similar to the $40 each cusco ones) but for half the price. I will order these within the next week. However, it cost the same to post 1-3 sets. So if anyone here is interested, let me know via pm, cause this may save you a few bucks

Benny,

With the centre console, the shifter surround just pulls off. But you need to give it a good tug! I think there is two screws and the top bit pulls out too

**bennjamin** · 14-08-2010 09:05 AM

Thanks a million guiz -

Just to confirm - the gearknob
surround comes off easy , but the top section ( the entire facade covering the climate control vents hu etc) unclips at the bottom
then i feel resistance and worry to pull any further. It's pretty soft plastic dam these hondas.

**p3p5y** · 14-08-2010 09:41 AM

There should be a guide on honda-tech or so that I followed with step by step pics that you will able to follow. Can't dig up the link right now as I'm out and about.

The end result will appear like so http://yfrog.com/c8wyvj