***Official What did you do to your EK today***

[ek4-guy]

Thread needs a kick along

i know there is no turbo yet and thats because i want to run the b18c for a few weeks before turboing it

and i know it's a mess valve cover will be getting painted, wires and hoses tucked a lil as well as catch can and coil will be mounted differently

i couldn't fit my injen intake on as the edelbrock sits lower than the oem manifold

so looks like i will need a new intake pipe for the turbo aswell

[dusAn]

washed it then it rained. fml

[na-118]

oldschool on the forums currently selling turbo setup for 2k man cheap as chips!
for the valve cover did you cut straight down to expose the timing gears and belt?
thanks

[ek4-guy]

oldschool on the forums currently selling turbo setup for 2k man cheap as chips!
for the valve cover did you cut straight down to expose the timing gears and belt?
thanks

I already have Dean's (DLO01) turbo kit so I'm more than good in that department

Yep I cut the timing belt cover off ages ago I just like the look of it

[na-118]

yeah like the look of it too haha
did you just use a hacksaw or something dl001 turbo kits off chops!

[DNYALL]

Installed mugen extractors, hi flow cat and custom catback

oooh nice

[ek4-guy]

yeah like the look of it too haha
did you just use a hacksaw or something dl001 turbo kits off chops!

i used i grinder to take the bulk off then used a dremel to finish it off

[57U-00]

cannon exhaust install fail over the weekend however getting it installed professionally quite cheap tomorrow morning costing me a little extra because i won't let them hack apart my stock exhaust, just incase I want to change it back... and I'm asking for the stock exhaust back as well, which means fabricating new piping which also means its costing me $90 instead of $60... but still... can't complain...

[Alvis]

Integra Blades VS EK4 Wheels.....
Changed them back to EK4 ones as the blades had bald tyres.
What do you guys think of polished EK4 wheels?

I like the blades (very rare to see) - they give the car a bit more of an edge being polished. What size are they - 16s? EK4s are ok on hatch (seen some on sedans and just doesn't look right IMO), but if you polished up the EK4s they'd look pretty schmick too... my 2 bobs worth anyway

[sangyz]

aint blades 15's?

[na-118]

blades are 15inch thanks for your input on the edge of polishing the ek4 wheels just ahvn't seen enough ahha

[Alvis]

can't you get tyres changed over to blades if EK4s are same size anyway...?