Calibrating the Voltage on the TPS

[zropts]

No load or tension when at CT.

I set my TPS now on CT at about 0.53V and WOT at 4.17V. This is the best reading I could get within the range in the 98-01 Teg manual.

As before I can get WOT at 4.5V but CT will be 0.85V which the voltage cannot be adjusted down due to the TS screw. The TS screw can only adjust the voltage 'UP'.

I can also achieve CT at 0.48V but then WOT is at roughly 3.86V therefore I cannot adjust WOT voltage up.