Calibrating the Voltage on the TPS

[beeza]

How did your car run with the tps gone?

[beeza]

Dun worry,I just found my answer:

http://www.youtube.com/watch?v=JGAJ7w2OJrg

Yes,the tps is rooted.

[Mikecivic78]

Does TB gasket need to be replaced when doing this job?

[stevo716]

Does TB gasket need to be replaced when doing this job?

if its not ripped or nething u can reuse, otherwise yes

[Mikecivic78]

if its not ripped or nething u can reuse, otherwise yes

Thanks. Any idea on cost of gasket?

[stevo716]

Thanks. Any idea on cost of gasket?

eh 5 bucks if that

[Mikecivic78]

eh 5 bucks if that

Cheap As

Cheers mate

[stevo716]

Cheap As

Cheers mate

yeh paper gaskets are cheap

[beeza]

Dun worry,I just found my answer:

http://www.youtube.com/watch?v=JGAJ7w2OJrg

Yes,the tps is rooted.

The problem was the wires were mixed up,the map sensor and tps sensor wires were around the wrong way.

Does TB gasket need to be replaced when doing this job?

As steve said.I rang Honda yesterday and they dont sell tps gaskets cause the tps is riveted on and therefore will never be seen..

[beeza]

I'm really stoked this thread is getting views it deserves..not for the work i did but for the benefits this yields..hope Ya'll do it and the other DIY,modifying the TB for more airflow!

[DB8R]

Sorry for this being my 1st post been browsing and seen this post,

Recently my ECL came on with code 7 which was TPS replaced this but I can't seem to get the volts setting right on close it's reading 0.50v and on full throttle it reads 5.34v how do I go and set this up, am running 70mm Blox throttle body which I have not had any problems with previous TPS sensor

Dont no if am doing something wrong

Thanks for your help

[vinnY]

try to adjust for WOT first then tweak for a closed throttle

if you check a few posts back of mine I actually list a range, just as long as you're between there you should be right