***Official What did you do to your EK today***

[Tai]

You shoud of left the middle grill black.

Looks so dodgy when u spray it white as well, everyone will know the front bar has been changed or will have suspicions its been in an accident.

Should of gotten a EK9/EJ8 front bar as well, colour coded moulds look tacky.

[Alvis]

I probably would have left the bumper grill black - gives it more of that clean OEM look - but I think the colour coded bumper moulds are fine - same as JDM Si spec

Not sure if ur getting a front lip, but an OEM front grille would help finish it off at the front

[tylerjames]

Front gill and lip are next on my shopping list.

I didn't realise the bumper grill was even black?
Wasn't on the bumper I had before, wether that suggests something or not?

+ door/bumper moulds look wayy better colour coded then the original black strips IMO.

[Tai]

Bumper grill are all black as standard, if you're previous one wasnt black then it was most likely replaced by previous owner or been in an accident.

Front gill and lip are next on my shopping list.

I didn't realise the bumper grill was even black?
Wasn't on the bumper I had before, wether that suggests something or not?

+ door/bumper moulds look wayy better colour coded then the original black strips IMO.

[tylerjames]

grr. would have told the panel painters if I had of known better.
thanks for the heads up.

[Riced_Civic]

i didnt do any thing to it but i did sumthing for it.

bought a type R rear sway bar and ASR brace.

[jks24]

removed my wing few days ago..

[mugen_ctr]

resprayed my sir lower lip, matt black...

[D16EK1]

got my front disks slotted (H)

[DNYALL]

just sprayed my track front bumper and rear bumper with a spray can gloss black. sik.

[Alvis]

got my front disks slotted (H)

So were they just your stock factory disks? How much did they charge?

[3KNST9]

new front bar without molds + hid kit + front ek9 lip but havnt took a picture with lip on it yet