Page 4 of 5 FirstFirst 12345 LastLast
Results 37 to 48 of 60
  1. #37
    What wire did you splice into for the 12+ volt wire on the LOC? I think it's the yellow one...

  2. #38
    Member Array
    Join Date
    Aug 2010
    Location
    Adelaide, South Australia
    Car:
    MY11 CU2 Lux MT
    Quote Originally Posted by oh_lol View Post
    What wire did you splice into for the 12+ volt wire on the LOC? I think it's the yellow one...
    Hi mate,

    I can't remember, and my trim is all in place at the moment so I can't look. But the wiring diagram for the CU2 with Premium Audio says that it is indeed a Yellow wire going into the Amp in the boot. I spliced into this wire to power both the SOEM4 and the Rockford Fosgate 360.2. There is plenty of headroom on the amplifier power supply to run a couple of extra low wattage items.

    To be certain though I always check the factory wires using a Multi Meter before actually cutting into anything.

    Cheers.
    2011 Accord Euro Luxury 6MT

  3. #39
    Newcomer Array
    Join Date
    Jan 2007
    Car:
    Euro Navi 2006
    Has anyone done it to Euro with SatNav as it has an Amp in a boot area? If so what have you used? Any issues?

  4. #40
    Member Array
    Join Date
    Aug 2010
    Location
    Adelaide, South Australia
    Car:
    MY11 CU2 Lux MT
    Quote Originally Posted by tuppelo View Post
    Has anyone done it to Euro with SatNav as it has an Amp in a boot area? If so what have you used? Any issues?
    I believe that the 'Premium' audio system is the same in all three versions of the CU2, Base, Lux and Lux Nav. Only the head unit is a little different in the Navigation version. But for this overhaul I never touched anything in the dash. All output was derived from the Amplifier mounted in the boot, which as far as I can tell is the same in all three versions.

    Cheers.
    2011 Accord Euro Luxury 6MT

  5. #41
    Newcomer Array
    Join Date
    Sep 2010
    Location
    Sydney
    Car:
    Accord Euro cu2
    Hi JustRight,
    Thank you for Sharing :-) I am thinking to upgrade mine too but I got few questions:
    - where did you place the front tweeter? Does the tweeter for 165vr fits nicely without having to drill a hole on the door trim?
    - where did you place the tweeter on the rear door?
    - how to remove the parcel rack (the one close to the rear windscreen) in order to replace the speaker?
    Thank you for your help:-)

  6. #42
    Member Array
    Join Date
    Aug 2010
    Location
    Adelaide, South Australia
    Car:
    MY11 CU2 Lux MT
    Quote Originally Posted by tonymulia View Post
    Hi JustRight,
    Thank you for Sharing :-) I am thinking to upgrade mine too but I got few questions:
    - where did you place the front tweeter? Does the tweeter for 165vr fits nicely without having to drill a hole on the door trim?
    - where did you place the tweeter on the rear door?
    - how to remove the parcel rack (the one close to the rear windscreen) in order to replace the speaker?
    Thank you for your help:-)
    Hi there mate,

    The Focal tweeter fits exactly within the standard location on the front door trim where the factory tweeter sits. You need to run additional wiring as the Focal tweeter is powered from the Focal crossover. I found that it was possible to remove the plastic fitting for the factory tweeter from the trim. Once that was done the plastic mount that Focal provide is an exact fit in the hole left behind. Very convenient !!!

    However the rear tweeters are a different story. To fit them I had to actually cut a hole in my rear door trim !!! With very careful use of a Dremel the pictures below show the result.


    Click to view full size!



    Click to view full size!


    To get to the rear speakers it isn't necessary to remove the entire parcel shelf. The plastic grilles over the speakers will pop out. Use a thin broad bladed tool under the front edge of the speaker grille and lever upwards firmly. The front clips should release allowing you to remove the entire grille. You can kind of see what I mean in this picture taken through the rear window.


    Click to view full size!


    Removing the Sub-Woofer however is a much bigger problem. To do that you do need to remove the parcel shelf. That involves removing the 'C' pillar trims and the special air-bag retaining pins in the 'C' pillars. The best thing is to seach the Web for a copy of the CU2 Service Manual which contains detailed instructions and pictures. (That's what I did)

    Cheers, and good luck.
    2011 Accord Euro Luxury 6MT

  7. #43
    Newcomer Array
    Join Date
    Sep 2010
    Location
    Sydney
    Car:
    Accord Euro cu2
    Thank you so much for your detailed explanation JustRight.

  8. #44
    Newcomer Array
    Join Date
    Dec 2008
    Car:
    Accord Euro Luxury
    Hi All

    Just got the MY12 Lux Sat Nav, great car but as you know bad sound system, Im thinking of having all this done but does anyone know of a place in Sydney where I can get it done Professionaly?

    Any help would be appreciated

    Thanks

  9. #45
    Hello,
    As i see you have changed your audio system.
    DO you know where exactly is original amplifier of Premium Audio System?

  10. #46
    Member Array
    Join Date
    Jun 2010
    Location
    Melbourne
    Car:
    Accord Euro 03
    In the headunit

  11. #47
    Quote Originally Posted by marquee View Post
    In the headunit
    really?

    so it means that there is no external amplifier in premium audio system?

    As i know that in accord USA model they have external amplifier next to the glovebox...

    Euro model doesnt have external amplifier?

  12. #48
    Newcomer Array
    Join Date
    Dec 2007
    Location
    central coast
    Car:
    08 Accord Euro
    i have a 2008 cu2 luxury navi and just wondering if you know what kind of sound system the accord euro cu2's run eg bosch or is it all panasonic cause i read futher back the amp is a panasonic
    i am trying to find out so i can get an bluetooth car kit installed and all the installers want to know is the system a bosch because it will need a cable that costs $150 alone and then i have to buy the bluetooth kit itself
    any help would be great

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBadvanced CMPS v4.1.3


Terms and Conditions
Ozhonda.com is in no way affiliated with the Honda motor company or Honda Australia in anyway whatsoever.