Enkei NT03+M on DC5R - Thoughts?

[Nuci]

Shit yeah those black ones look hott. Wonder if i can squeeze 9.5s on there. Anyone know if 9.5" rims with a +38 offset will fit the DC5R???

[stevanbonic]

Shit yeah those black ones look hott. Wonder if i can squeeze 9.5s on there. Anyone know if 9.5" rims with a +38 offset will fit the DC5R???

no chance, rear inner lip will grind on the trailing arm, need at least +30 to run a 9.5 succcessfully.

[Nuci]

So ideally i'd want 18x9, +38 offset. That would fit and look flush-ish?

[stevanbonic]

minimum +35, im +35 in the rear with 1.5 degrees neg and im still grinding the rear under heavy cornering fml, new suspension cant come soon enough if its enkei they should have it in +30 or +35 which is more ideal

[Nuci]

+38 is the lowest it goes for that rim in that size... Considering its not a track car and that I have rolled guards and fully adjustable suspension (height, camber) will i be able to run them?

[stevanbonic]

you can run them, a mate runs the same size and offset with XD9's, just check the clearance after they are on, the N+ should be stiff enough to handle the rear compression. I think the black DC5 page before is on +9.5 but they are low 20's offset off memory, looks soo nice but extremely non-functional...

[Nuci]

Looks like I know what the next purchase is then Im over my FN2R rims. They look ok for stock wheels, but they weigh a bloody ton!

[stevanbonic]

should look great!! I was surprised how light my RPF's were, X9 rim was lighter than the standard X7 rim

[Perry]

..in this colour

What's the specs on these babys?

[AE092]

I couldn't tell you as I don't know but they are a Limited Edition version based on the +M version of the NT03's - they look to be at least 9.5inch wide, 10 would be my pick.

[so_rnb]

The old Centrax DC5 had the older NT03's on theirs. They were 10 spoke ones.