EP3 Type R

[Nepolian]

Lol, just realized I had my undies inside out! :S

[bennjamin]

ive actually gone thru entire working days and found out my shorts or shirt on inside out. Not to mention wearing a sock on the wrong foot !

[SuperSteve]

Lol, just realized I had my undies inside out! :S

Hate it when this happens. Especially when I've got skid marks

Sent from my Desire HD using Tapatalk

[Poeter]

Lol I've accidentally wore mismatched shoes to work before. Drove home before anyone noticed and save myself the embarrassment

*Facepalm*.

[flubbar]

i've had my pants rip where the butt is. thankfully nobody saw and i quickly wrapped a jumper round my waist and went to buy a new pair of jeans.

[SuperSteve]

i've had my pants rip where the butt is. thankfully nobody saw and i quickly wrapped a jumper round my waist and went to buy a new pair of jeans.

I saw it and I'm still slightly blind in my right eye

Sent from my Desire HD using Tapatalk

[Nepolian]

I saw it and I'm still slightly blind in my right eye

Sent from my Desire HD using Tapatalk

Is that the photo you showed me and tried to pass it off as a chicks butt??

[RPS.13]

Some pics to wet your appetite's:





Guys need a bit of help with my rear coilovers...?

I'm at a bit of a loss and cannot figure out why the left side is higher than the right... The left side I maxed out today, and it has a 1.5-2 finger gap between the guard and tyre. The right side still has about 25mm of thread to wind down, however this side has less than 1 finger gap. Coilovers: BC BR's base height adjustable.

Apart from adjusting the coilover height, am I missing something??? I checked, it doesn't look like anything is bent, not signs of rear end damage under the car...

[Nepolian]

Forget my post in your other thread.....check/adjust the preload spring height then just check how far out you are in the seat?.

[RPS.13]

Cheers thanks Nepolian! yeah I left the preload as set from the box... I'll recheck them when I rip them out next time.

[Nepolian]

Cheers thanks Nepolian! yeah I left the preload as set from the box... I'll recheck them when I rip them out next time.

The preload is usually done with height. eg BC (BuddyClubs) use 200mm etc). Can be checked whilst on car!

Lol, wished I have the balls to use that kind of offset.

[RPS.13]

The preload is usually done with height. eg BC (BuddyClubs) use 200mm etc). Can be checked whilst on car!

Lol, wished I have the balls to use that kind of offset.

Okay cool, i'll check them on the car. If that doesn't yield any result, then I'll flip them. Yeah the BC BR site says, their preload is set 5mm up from when the spring seat touches the spring.

Haha, do it... you know you want too! You don't need balls, more like half a brain... lol