EG5 Vti Water Temperature needle goes to High.. Whats wrong with it??

[hmetro24]

I had the same problem, I read that trick were you turn the heater on full and run the engine with the radiator cap off (stationary) gets rid of air pockets... then installed a new radiator cap.. fixed

Do this trick and rev around 2000rpm for 30 40 seconds, and you should see that coolnat level went down if there was air inside the cooling system

[~Sp33~]

Let me explain a bit better than the title. my eg cluster temp needle goes to High but when i pop the bonnet and feel around the engine and the radiator. it is actually just warm not hot... and no steam coming out anywhere. and no weird noises coming out from engine. the radiator fan spins... whats wrong with my car? head gasket blown? but i cant see any oil leaking or residue in the coolant. thanks guys. let me know what you think.

Because your hands must be heaps more accurate than the temperature gauge.

[whitecomet07]

Because your hands must be heaps more accurate than the temperature gauge.

thanks for the reply. if you think make fun of peoples questions on ozhonda is your sunday mundine. then gtfo. dont spam a thread.

[whitecomet07]

can one of the admin close this thread? i found the problem. the fan motor isnt working. thanks admin. so losers dont bring this thread back alive.

[~Sp33~]

Maybe your rad fan isn't working, oh wait you said it works fine.

the radiator fan spins...

Oh wait

the fan motor isnt working.

so losers dont bring this thread back alive.

I'm sure this thread could be very useful to future users who feel around their engine bay to see if their motor is overheating.

[whitecomet07]

quit wasting your time being a keyboard warrior. go do something useful. enough of this.