DIY gear change & speed light for RSM

[asiansquad]

How would i connect this to a vafc??

which wires do i have to link the led's to??

[dundas]

look on ur VAFC install guide/ instruction manual..
it MIGHT have it on there.. not 100% sure---
does ur VAFC have rev output? if it does.. u can do it-
but yeh.. take a look in ur instruction manual.. this is how mr learner found it---

[Jase EK]

just wondering, for the (-) wat wire did u connect that 2 rsm ? is it the white, for negative trigger ?

[j-specAccord]

bump.. i need some help on installing this ?? anyone help

[dundas]

LOL damn this is old thread.. but anyways .. wat help is needed?
the white wire on the RSM is what you want to connect up and also a power source for the light. (pretty sure )
anyways.. seriously Look in your instructions from the RSM and it will show you how towards the back i think. It has been a while...

[panda[cRx]]

whoa only just noticed this thread now.... velli kewl

[aStRooo]

connect it to the white wire from the RSM for ground (thats the switching ground) and splice into the RSM or the ECU's power

[dundas]

u can really go to any power source... so what ever you can get your wires on. give it a test and see if it works... (set rev @ lowest) rev to that particular point and your light should work

[connorling]

just a question, which wires do u connect to the light?