ok finally got a video. not well filmed but I did the best I could. it's in a awkward spot to film :/

as you can see it just won't sit in properly no matter what, I guess if the circular flange could be divided into four sides, one side is always sticking out, just like if the opening in the gearbox was too small. if the top goes in the bottom stays out, and vice versa. so it's just tilting it's edges in if you know what I mean. the flange as a whole just won't go in.

http://s582.photobucket.com/albums/s...t=IMG_1713.mp4

you can also see the small gap when it's sitting square with the opening here if you look carefully.



I've been trying turning the engine to get it to mesh and still exactly the same. can't even feel anything through the starter when the flywheel is turning.