Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
guy i know it may be shit to some... but i tryed this is my first DIY and hope some of you like it C&C welcome...
aim:
keep the wife happy... and look cool
tools:
Phillips head s/d
steps:
step one:
remove the 3 screws on each side one screw u cant see because its just under the chair and undo the gear knob witch will unscrew anti-clock wise.
step two:
take the gear surround off by slowly pulling it up and back. no picture needed unless u ask ill get one
step three:
remove the 4 screws holding the console in place. put the new one in and replace the 4 screws 2 on each side then that lil unit will come out....
put the new on in its place and do the steps backwards
now at this point i have gotten the shits with my gear boot and hate how it sags so for a cheap (free) way off stopping it i put a rubber washer to hold it in place..
step four:
i put the surround and gear boot back in place.
step five:
put the locking nut and gear knob back on
and last but not least add a can of coke!
Bookmarks