Yea, I remember the guy that was selling them vteckid became very unreliable towards the end of last year. Alot of people reporting that they didn't recieve their headers or they came late... sighh.. A good reasonably priced header and i missed out
does anybody know if the header would fit with the stock jdm catyl ?
I don't think it's bolt-on, I know ben has the kiddracing headers. Any input from someone on that? I know they come with a test pipe so my only reasoning for that would be it doesn't work with the stock cat, unless of course you had it welded on by an exhaust shop.
Correct ^^^ you'll need an aftermarket cat to be welded up where the test pipe is.
The stock cat is a part of the 2-1 section from the stock header. It would be a lot of trouble to make it fit. Sure it could be cut it up to fit onto the Kiddracing item, but why would you bother??? Plus you'd have to cut up your mid pipe section to make it fit & your o2 sensor wiring probably will need to be lengthened/extended to suit.
Are the gasket sizes common? I don't think mine came with gaskets...
My EG5 build "Try to move in with a hot easy gurl. I've got a mate who does his house mate when he gets drunk. This way you can cure some of the loneliness and also save $$$ on prosties. Just remember to act like nothings happened the next day because if you get attached your laterz mate."
Are the gasket sizes common? I don't think mine came with gaskets...
Yep, it is a standard 2.5" 3 hole gasket. I got it from my local Autobarn, probably a tad cheaper if you go to an exhaust shop. The other side you use the doughnut gasket supplied. Pretty sure you can get them from exhaust shops too, in case it didn't come with it.
My EG5 build "Try to move in with a hot easy gurl. I've got a mate who does his house mate when he gets drunk. This way you can cure some of the loneliness and also save $$$ on prosties. Just remember to act like nothings happened the next day because if you get attached your laterz mate."
Bookmarks