after reading through the DIY guides in a US and indian forum - managed to do the same myself.
its still not finished, now i need to figure out a way to get the wire from engine bay into the cabin.
just the rough work for now.
quite a surprise when i am getting the vtec on on this. I thought I drive like a granny already so i imagined i should be getting eco vtec most of the time, but the vtec demands even lighter footwork :P
for those who wants to do the same I am happy to help you out.
funny when the light comes on and i go my eco vtec just kicked in yo~~~~lol
Cut a hole in the rubber of the engine loom on the firewall. Feed the wire through there. And then seal it back off with electrical tape when you're done. Easiest.
Bookmarks