Thanks for the input all. After some thinking I went with the CT icebox.. and got one shipped pretty fast from heeltoe.

GOtta say, i was a bit worried abt taking the bumper off at first, but i found a youtube video which helped.

Thought I'd share a few photos which might help those who want to do the same.

BUmper off. The instructions tell you where the clips are



The stock resonator to take out. Wasnt easy..! Unclipping the mudguard helped wiggle out the intake pipe which is connected inside the engine bay




The icebox's inlet horn now on. Not very pretty, i know


The stock inlet pipe, now connected to icebox lid. This was a pain to put on.. really a 2 person job.




2 metal spacers/fasteners thingo that I had to take out so the icebox lid could actually screw down (thanks to aaronng for the tip). I've read a lot of ppl had the same issue securing the lid on for a tight seal.



And at last...final result.WIth the CT Engineering decal I stuck on the lid.. that itself added an extra 5hp..lol.




Hope this is helpful. My take on the results in a next post