| 
		
		
	 
	
	
		
			
	
	
		
		
			
				
				
				
					Eating Oil
				
					
						
							Hey guys, I've done my research and I know that loosing 0.5L of oil per 1,000kms is normal.My AP1 has chowed 3.5L over 3,500kms, so double the normal amount.
 
 details:
 - year: 2000
 - runs perfectly
 - @103,500km's
 - cusco catch can
 - wider throttle body
 - hits VTEC about 6 times a day
 - BP ultimate only
 - filled with OEM 10w-30w oil @100,000kms
 - Since then been topped up with Motul 5w-40w, so far added 3.5L
 - no white residue in oil
 - does not blow green smoke, but there's a small puff of black smoke when it hits VTEC while the car is stationary in neutral, nothing in low revs. Sort of smells like unburnt fuel.
 - exhaust tips turn black pretty fast, BP fuel could be the reason?
 - not sure if I have the new oil jet bolts
 - when checking the oil level, the oil from the dipstick is more black than gold, even though I've added 3.5L over 3 months
 - normally get 330kms per full tank, almost all city driving
 
 
 Apparently catch cans should help lower oil consumption... so should using 5w-40w oil, but my car has the munchies.
 
 Anything to be worried about?
 
				
				
				
					
						Last edited by Simmoyo; 27-12-2011 at 10:40 PM.
					
					
				 
	
	
		
		
			
				
				
						
						
				
					
						
							
	the catch can doesn't  reduce oil consumption, itjust stops it from going back into the intake and burning in the cylinders
		
			
			
				
					  Originally Posted by Simmoyo   Hey guys, I've done my research and I know that loosing 0.5L of oil per 1,000kms is normal.My AP1 has chowed 3.5L over 3,500kms, so double the normal amount.
 
 details:
 - year: 2000
 - runs perfectly
 - @103,500km's
 - cusco catch can
 - wider throttle body
 - hits VTEC about 6 times a day vtec causes u to burn oil..
 - BP ultimate only
 - filled with OEM 10w-30w oil @100,000kms is this the right grade?
 - Since then been topped up with Motul 5w-40w, so far added 3.5L is this the right grade?
 - no white residue in oil
 - does not blow green smoke, but there's a puff of black smoke when it hits VTEC in neutral, nothing in low revs. Sort of smells like unburnt fuel. running rich
 - exhaust tips turn black pretty fast, BP fuel could be the reason? running rich. not BP's fault
 - not sure if I have the new oil jet bolts
 - when checking the oil level, the oil from the dipstick is more black than gold, even though I've added 3.5L over 3 months Engine's just dirty?
 - normally get 330kms per full tank, almost all city driving
 
 
 Apparently catch cans should help lower oil consumption... so should using 5w-40w oil, but my car has the munchies.
 
 Anything to be worried about?
 
 I think your oil burning is due to blowby at the piston rings. Perhaps your rings are a bit worn. Maybe get a compression/leakdown test done?
 
				
                                       
                                 
				
		        		S P A M | W O R K S
hehe.PHC
 
	
	
		
		
			
				
				
						
						
				
					
						
							either that, or the FRM on the cylinder wall is thinning out.
						 
	
	
		
		
			
				
				
						
						
				
					
						
							The problem is VTEC 6 times a day.. :P
						 
	
	
		
		
			
				
				
						
						
				
					
						
							pfffft it loves it...
 I hope its not the rings or the walls, Ill get it pressure tested in a few months. thanks
 
	
	
		
		
			
				
				
						
						
				
					
						
							try running a thicker grade oil...15-50 or something like that and see how it goes...
 
	
	
		
		
			
				
				
						
						
				
					
						
							How you do hit vtec in neutral?
						 
	
	
		
		
			
				
				
						
						
				
					
						
							while your rolling   
	
	
		
		
			
				
				
						
						
				
					
						
							Check the pcv, Do a leakdown test, use thicker oil.
						 
	
	
		
		
			
				
				
						
						
				
					
						
							Think i've got a similar problem. Trying 10w-40 motul now seeing how it goes. fml
						 
	
	
		
		
			
				
				
						
						
				
					
						
							oh that's right iforgot about the FRM. I lose a bit of oil from that too. Some say preludes lost a bit of oil from the factory, all cos the FRM sleeves don't hold oil as well or something
						 
				
                                       
                                 
				
		        		S P A M | W O R K S
hehe.PHC
 
	
	
		
		
			
				
				
						
						
							
						
				
					
						
							its wear and tear. The FRM walls are thinning, therefore oil escapes to the combustion chamber and burnt off. 
 That is why in most cases of S2000 losing oil, it cannot be traced where its gone to.
 
 FRM is used on H22A, C30, and the F20C
 
 
	
	
 
	
	
	
	
	
	
	Tags for this Thread
		
		
		
		
			
				 Posting Permissions
				
	
		You may not post new threadsYou may not post repliesYou may not post attachmentsYou may not edit your posts  Forum Rules | 
Bookmarks