EP3 Type R

[mr_kentu]

hi all, im just new about ep3. got question.
is there any direct replacement for hid bulb and balast for 2002 ep3 ? 1 of my headlight is not working

** i found the answer from the earlier post in this thread. i search on ebay and i found this
http://www.ebay.com.au/itm/Philips-H...item3cb0489c70
it says for honda s2000. will it be the same ?

[keepitlow]

Just bumped into this while I was searching for some light bulb size for EP3R

EP3 Pre-Facelift

Headlights: H4 (Main and Dipped) Dual Filament
Front Position Light: 501 / 194 / T10
Front Indicator: Offset Pin BAU15S
Front Fog Lights: H11
Side Repeater: 501 / 194 / T10
Interior Lights: 31mm Festoon 269
Interior Boot: 501 / 194 / T10
Rear Fog Light: 382 / P21W / BA15S (Single Filament)
Rear Indicators: Offset Pin BAU15S
Rear Reversing Lights: 382 / P21W
Brake Lights: 380 / P21-5W (Dual Filament)
Centre Brake Light: 501 / 194 / T10
Rear Number Plate: 501 / 194 / T10


EP3 Facelift

Headlights: H1 (Dipped), HB3 (Main)
Front Position Light: 501 / 194 / T10
Front Indicator: T20
Front Fog Lights: H11
Interior Lights: 31mm Festoon 269
Interior Boot: 501 / 194 / T10
Rear Fog Light: 382 / P21W / BA15S (Single Filament)
Rear Indicators: Offset Pin BAU15S
Rear Reversing Lights: W2 / 921 / 912 / T15
Brake Lights: 380 / P21-5W (Dual Filament)
Centre Brake Light: 501 / 194 / T10
Rear Number Plate: 501 / 194 / T10

[Lukezen27]

Just bumped into this while I was searching for some light bulb size for EP3R

EP3 Pre-Facelift

Headlights: H4 (Main and Dipped) Dual Filament
Front Position Light: 501 / 194 / T10
Front Indicator: Offset Pin BAU15S
Front Fog Lights: H11
Side Repeater: 501 / 194 / T10
Interior Lights: 31mm Festoon 269
Interior Boot: 501 / 194 / T10
Rear Fog Light: 382 / P21W / BA15S (Single Filament)
Rear Indicators: Offset Pin BAU15S
Rear Reversing Lights: 382 / P21W
Brake Lights: 380 / P21-5W (Dual Filament)
Centre Brake Light: 501 / 194 / T10
Rear Number Plate: 501 / 194 / T10


EP3 Facelift

Headlights: H1 (Dipped), HB3 (Main)
Front Position Light: 501 / 194 / T10
Front Indicator: T20
Front Fog Lights: H11
Interior Lights: 31mm Festoon 269
Interior Boot: 501 / 194 / T10
Rear Fog Light: 382 / P21W / BA15S (Single Filament)
Rear Indicators: Offset Pin BAU15S
Rear Reversing Lights: W2 / 921 / 912 / T15
Brake Lights: 380 / P21-5W (Dual Filament)
Centre Brake Light: 501 / 194 / T10
Rear Number Plate: 501 / 194 / T10

Nice

Benny we need a Sticky with this type of info...

[JohnO]

You deserve a rep point there!

Sent from my HTC Incredible S using Tapatalk

[UNA91]

So apparently our seats have some sort of knee/leg extender? Is that so? cause that'll be nice haha. Anyone know how or where i can find how to adjust it? It's meant to be something like this...

Also, I would like to replace my right side thigh bolster. Have looked though ebay and found a seller called 'capital.seating' selling bolsters for the ek9 and euro cl1 recaros, just wondering would they fit the ep3?

[RPS.13]

You just put your hand under there and pull it forward.

[wtfhax]

lift it up a bit first then pull forward

[[daan]]

Yes feel underneath the front of the seat, pull up and forward (as above) personally i just leave it alone its comfy already, but good to clean all the built up dirt that gathers in there

capital seating dont have bolster for the sportline series last time i checked. it would be worth sending them an email with a picture and confirm, though... i'm also not 100% if it can be changed like the SR3/SR4 as they are detachable bolsters. the EP3 Sportline i think is actually stitched to the main part of the seat (can someone confirm)

[UNA91]

Hmm, cause i thought the CL1 recaros were the same as the EP3, just difference colour and texture material...

[Perry]

Hmm, cause i thought the CL1 recaros were the same as the EP3, just difference colour and texture material...

You are correct on that.

[RPS.13]

Last time i looked at Capital Seating they had the bolster replacements, but that was early 2011 i looked. That was back when i needed a lever replacement. Got the part name from there and ordered the part from here: http://www.idealseat.com.au/

You can email on: idealseat@hotkey.net.au

Price wasl pretty similar to the UK.

[Lukezen27]

Last time I was IMG to pickup an 02 sensor the owner told me the EP3 he's currently got will more than likely be their last import for this model...

Good new for us in keeping their value I'd say