[CU2] HIDS *installed* in a Standard CU2

[redseven]

Resurrecting an old thread, I'm also interested in getting an HID kit for my standard CU2 without HIDs.

I found these specs in the manual:
High beam: 12V - 60W(HB3)
Low beam: 12V - 35W(D2S) or 12V - 55W(H1)

So that means even CU2's with factory HIDs only have it on the low beam, not a bi-xenon hi/lo setup? To those who have done the mod, do you have to use the headlight adjustment switch to get them to point lower for less glare? The current low beams are in a projector housing so I assume dropping in D2S bulbs wouldn't cause too much glare compared to reflectors.

Any recommendations on good kits which aren't too expensive? Coverage, color temp and cutoff should be close to stock HIDs.

Edit: found out the 2011 Euro and Japan Accords have bi-xenons, adaptive cornering headlights and a light control system... I want these! http://tsx.acurazine.com/forums/showthread.php?t=809360