Well, as usual, progress was a little slower than I'd hoped.....
I got the rad heat shield and thermo fans on...but I haven't hooked up the relay to switch them on and off yet.
I also didn't get the demon chip in, or the wide band O2 sensor in....

But I did get the fans in, and drive the car carefully to get it up to operating temp, and it all works fine....

Anyhow, pic time....
Pull the rad out.... Thats the easy part....


Here is the heat shield, and my plans for it....


Bolt thorough and fix the bolts with nuts from the back.

With nylon luck nuts to hold the fans......

Bolt them down, nice and tight......

And a piece of rubber seal along the top an bottom to reduce rubbing, vibration and wear....

And all finished, ready to go back in.......


I didn't get pics of me putting the rad back in.
By that time I was way too frustrated to take pics... LOL (Not to mention the things I accused it of having done to my mother....!)

But it is back in, and everything works, and it stays cool while running,


Though, the top radiator tank does seem to get quite hot, but the engine temp is good while running....