ek4 clusters into an ek1

[bladed_yoshii]

i currently have an ek1 looking around ebay to find a cluster with a rev tach in it. im only looking for one which have the red line at 7k rpm would these fit into a ek1? engine is still stock (so the d16y4) and would it put anything out?

edit: looking for an ek3 cluster not 4 my bad

[ericl33]

i currently have an ek1 looking around ebay to find a cluster with a rev tach in it. im only looking for one which have the red line at 7k rpm would these fit into a ek1? engine is still stock (so the d16y4) and would it put anything out?

edit: looking for an ek3 cluster not 4 my bad

here.

[impossi13le]

You can either get ek gli cluster or ek4 cluster. They will be plug and play and the tacho will work, given the clusters are still in good condition. Only difference is gli goes to 8k and ek4 goes to 9k (correct me if I'm wrong)

[EKVTIR-T]

Use a Gli cluster with factory tacho

You can see the fitting instruction here http://www.ozhonda.com/forum/showthr...from-your-Cxi!

[bladed_yoshii]

are the gli the same as the ek3? and will it fit into the ek1

this one?

[bladed_yoshii]

end eric i was just seeing if the ek3 clusters will fit into the ek1

[ericl33]

end eric i was just seeing if the ek3 clusters will fit into the ek1

seemed like you were looking for a Cluster.

all good, good luck, I recommend but a spoon cluster.

[bladed_yoshii]

cheers man ill have a look around for one they actully look sick

[EKVTIR-T]

cheers man ill have a look around for one they actully look sick

Spoon cluster is so rare and costs around $2000. Eric was joking

Just get a Gli cluster,very cheap,easy to fit and factory finish

[XB-16-AX]

Get an EM1 Cluster the red line point is 7800rpm and is higher than the EK Gli.

it should be a plug and play item.

[NeedVtec]

Get an EM1 Cluster the red line point is 7800rpm and is higher than the EK Gli.

it should be a plug and play item.

i dont see the point tbh

its a d16 not a b16

gli cluster should be fine.

[EKVTIR-T]

im only looking for one which have the red line at 7k rpm would these fit into a ek1? engine is still stock (so the d16y4)

Get an EM1 Cluster the red line point is 7800rpm and is higher than the EK Gli.

it should be a plug and play item.

Whats the point of 7800 red line?