prelude(91-95) complete break set up into civic (92-95)

**glen06** · 25-06-2012 06:30 PM

i havent seen people doing this conversion..but to they go straight fit like the tegs break setup goes into eg with no drama..

prelude got the 4x114.3 stud patter
civic (92-95) 4x100 stud patter

does it need to be straight fit or alot of customize.?

in case someone ask car got b16a2 not sure if the driveshaft will fit as well..

**connorling** · 25-06-2012 06:36 PM

U need the dc2 262mm knuckle then u can fit the brakes over as long as u redrill the rotor to 4x100.
It has been covered billion times.

**glen06** · 25-06-2012 10:20 PM

Originally Posted by connorling

U need the dc2 262mm knuckle then u can fit the brakes over as long as u redrill the rotor to 4x100.
It has been covered billion times.

update i got del sol break setup already..just wanted the 4x114.3 stud pattern
choosing prelude cause its cheaper other than 96-98 spec integra type R break set up