Injen cold air intake problems

[CivicTypeR]

Hello all,

I've just recently installed the injen cai on my ep3 and after I installed it I've had a few electrical problems.

My passenger side headlight does not work completely and the indicators flash rapidly.

During the installation I had to relocate the grouding wire and disconnect the battery. But thats about the only electrical-wise stuff I had to fiddle with during installation.

Any ideas?

[dc2screama]

Checked your fuses?
Or maybe burnt bulb?
Or try disconnecting your battery again for a few minutes then connect them up..

[mocchi]

grounding problem. make sure the grounds are connected properly metal to metal, or you plugged the wrong connector.

[CivicTypeR]

Yeah the ground wire is connected to a metal bar the instuction booklet told me to put it. Where is the ecu fuse? Maybe I should try reset it from there?

[mocchi]

Yeah the ground wire is connected to a metal bar the instuction booklet told me to put it. Where is the ecu fuse? Maybe I should try reset it from there?

what metal bar?
it needs to be connected to chassis

[CivicTypeR]

Found out the problem. Yeah it was connected to the chassis, except there was paint where I relocated it lmao silly me. Sanded it down for a good ground contact and now it works fine.

[Apu]

The paint should really matter unless there was a particularly thick blob. Look at all the other factory mounting points - they're all painted. You might want to just dab a bit if rust preventer on it or just spray some lithium grease on the area.