With that kit you will need to reuse ur original lower ball joint bolt, reuse your camber arm support plates, and the LHS tie rod has a grease nipple so you will need a grease gun. The sway bar bushes are Abit tight so you might have to trim Abit of it. Other than that it all fits ok. I recommend you replace your rack boots while your at it. Also there's a lock nut washer on the rack end, you can reuse yours but I would recommend new ones, they aren't expensive from Honda.
If you have any other questions just let me know.
If you have access to a press then you should change out your front lca bushes as well.
Reply With Quote
Bookmarks