I turboed my d16y4 with an ebay kit... has been fine......... if you want to get anything out of the turbo you should upgrade your ecu, get bigger injectors and fuel pump, ive being running 14psi (alot of timing taken out at top end) and increased my rpm limit to 8000, it has lasted 10, 000 ks and has been fine except the rings are on there way out... howeva if you flog the car enuf this is gunna happen.. all internals are stock and has been a very good car... GET A GOOD TUNE REGARDLESS OF COST.. hope this helped
how much power u were running if u dont mind me asking
honestly im not exacally sure because i havent put it on the dyno, but i dont think the figues are huge.. sumwhere around 300hp im guessing.. honestly its the power to weight ratio that makes it fast not much else, ive timed it down the 400 a few times most good runs getting about a 13.0, however with the rings being on the way out im trying to figure out with to rebuild this motor or go a b or k series
honestly im not exacally sure because i havent put it on the dyno, but i dont think the figues are huge.. sumwhere around 300hp im guessing.. honestly its the power to weight ratio that makes it fast not much else, ive timed it down the 400 a few times most good runs getting about a 13.0, however with the rings being on the way out im trying to figure out with to rebuild this motor or go a b or k series
niceee... guess the time slip is enough to indicate the power
Rebuild the motor an shoot for 12's man, do it hahaha, parts aint that expensive either
Best guide is the SERVICE MANUAL! I've been turbo for about a year now - all been well so far. And 300hp is a lot of power, what clutch are you running? Not too shabby for a 1.6 liter ay!
its a standard clucth.. its not helping the gearbox much, i try and be gental on the changes as much as i can but second and third syncros are pretty had it
Bookmarks