bending lines to fit itr PV

**junoki** · 08-12-2012 02:59 PM

so story is i splashed out for 5 stud conversion fr: AUDM ITR

as ive searched around regarding info on prop valve when going 5-stud, im a lil stuck here.

ive got this,
Pic 1.

im not sure if this is the right PV, as ive been reading you need 4040 PV from 90-93 integra, but i cant find any stamps on the PV i got (pic 1.) that its a 4040. Ive researched around and found that the one ive got pictured above is:

JDM ITR 98 4040 Prop Valve non abs --- can anyone confirm for me please?

ATM im running (on my car) full eg6 front and rear 262/240mm, 3030 PV (pic below of my current one)

Pic 2.

*Not my pic Btw, but its exactly what it looks like**

Looks like i have to bend my existing lines like (pic 2.) to fit (pic 1.), is that right?
(Not a good idea by what ive read around)

any help would be much appreciated

oh and i forgot already have 1' BMC and booster from ITR

Thanks

**mooshie** · 08-12-2012 08:47 PM

Bending lines is actually pretty easy. Get some old ones and practise and you will soon get the hang of it

**GU357** · 08-12-2012 09:19 PM

try not to put pressure on the lines where they screw in when bending them atleast, if u bend them dont hold the valve and push the line because that puts all the stress on the threaded ends.

**kcokla** · 08-12-2012 09:43 PM

If your bending lines - also consider taking it to a customization shop.

Bendling lines is not time consuming and very easy - provided you have the right tools

it can be done by hand but if you put a kink in it then your going to have to replace it!

becareful if your doing it by hand!