removing the abs fuse and abs light

[mocchi]

this information is actually wrong

you cannot reset the ABS ECU by disconnecting the battery, ECU or pulling fuses, you must perform the procedure with the SCS and brake pedal.

Fault in the ABS are stored in non volatile memory ( Not RAM like PGMFI ECU )

if you pull the fuse and drive around then put the fuse back in you may get a fault in the ECU for bad fail safe relay or low voltage.

shieeeettt honda master
had to reset abs ecu after engine swap, abs light came on for some reason
reset abs ecu using brake pedal like ecu-mun said. its like a brake pedal morse code combined with ign on/off